matapata Posted April 3 Report Share Posted April 3 After a few hours of pain, I finally figured out how placing panels works. I understood that if I click on the bottom side of the panel, it lays horizontally and if I click on the upper side, it lays vertically. I'd rather split it into 2 different items, which I could theoretically put into vertical mode and redo back using the wrench. Link to comment Share on other sites More sharing options...
Bulteer Posted April 4 Report Share Posted April 4 Are you talking about the half-block slabs of stone or planks? You can just put them in the crafting grid to cycle them through automatic / vertical only / horizontal only placement. 2 Link to comment Share on other sites More sharing options...
jumpityjumpjump Posted April 9 Report Share Posted April 9 (edited) On 4/4/2024 at 4:35 AM, Bulteer said: Are you talking about the half-block slabs of stone or planks? You can just put them in the crafting grid to cycle them through automatic / vertical only / horizontal only placement. Bulteer, I'm not OP, but I appreciate that information about putting the block in the crafting grid to set their orientation. Much like matapata I had to experiment to discover that where you place your cursor on the neighboring block dictates how it places. I actually ended up crafting a wrench to change the block orientation before I figured that out. Edited April 9 by jumpityjumpjump Link to comment Share on other sites More sharing options...
Maelstrom Posted April 9 Report Share Posted April 9 Kurazarrh has a guide series on youtubes that shows where to aim to place a slab in the desired orientation. After seeing that episode (in the first season) it made placing blocks MUCH easier. Link to comment Share on other sites More sharing options...
Recommended Posts